In the past when setting up a new circuit, I would be on the phone with
Verizon and they would see the MAC address, ask me if that sounded
right, and if the first 10 digits were the same as other macs in the
router, that was it. I never gave it to them, they would figure it out.
Unrelated, but I think that your loopback interface needs an IP address
for the Virtual-Access interfaces to bind to, since you are specifying
the Virtual-Template to be unnumbered to it.
Some commands to help you in the future with PPPoE and such...
"sh sss session"
"sh vpdn"
"sh users"
Thank you,
Seth Crimmins
Westelcom Internet
-----Original Message-----
From: owner-verizonisp@westnet.com [mailto:owner-verizonisp@westnet.com]
On Behalf Of network2k@juno.com
Sent: Tuesday, August 21, 2007 3:37 PM
To: verizonisp@westnet.com
Subject: New Verizon PVC
Hello, we are new with verizon east for DSL Resale, we finally got our
OC3 installed, which is up w/o any errors. We have not been able to get
any info from verzion how to setup the pvc.
We are using cisco 7206 and found some info on cisco site and our config
for atm/pvc is below.
basically the cpe isnt able to login or get a ip address when we connect
to test dsl lines we ordered.
have attached the sh interface as well.
not sure if part of it not working is when verizon had asked us for mac
address of router we had provided mac of ethernet interface (does that
mac address have to be assigned to OC3 interface as well?)
If some can please help out on this, we havent been able to get any
where with vz or if someone can please provide consulting
sincerely
jim
bba-group pppoe global
virtual-template 1
vc-class atm auto-pppoe
protocol pppoe
ubr 155000
create on-demand
pppoe max-sessions 200
!
interface Loopback0
no ip address
!
interface ATM1/0
no ip address
class-int auto-pppoe
no atm ilmi-keepalive
!
interface Virtual-Template1
ip unnumbered Loopback0
peer default ip address pool pppoepool
ppp max-bad-auth 3
ppp mtu adaptive
ip local pool ppoepool 192.168.40.20 192.168.40.50
show results for interfaces
ATM1/0 is up, line protocol is up
Hardware is ENHANCED ATM PA
MTU 4470 bytes, sub MTU 4470, BW 149760 Kbit, DLY 80 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ATM, loopback not set
Encapsulation(s): AAL5
4095 maximum active VCs, 0 current VCCs
VC Auto Creation Enabled.
VC idle disconnect time: 300 seconds
1 carrier transitions
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: Per VC Queueing
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Virtual-Access1 is down, line protocol is down
Hardware is Virtual Access interface
MTU 1500 bytes, BW 100000 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP Closed
Base VtMgr vaccess
Vaccess status 0x0, loopback not set
DTR is pulsed for 5 seconds on reset
Last input never, output never, output hang never
Last clearing of "show interface" counters 3w3d
Input queue: 0/4096/0/0 (size/max/drops/flushes); Total output drops:
0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Virtual-Template1 is down, line protocol is down
Hardware is Virtual Template interface
Interface is unnumbered. Using address of Loopback0 (0.0.0.0)
MTU 1500 bytes, BW 100000 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP Closed, loopback not set
Keepalive set (10 sec)
DTR is pulsed for 5 seconds on reset
Last input never, output never, output hang never
Last clearing of "show interface" counters 3w3d
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Virtual-Access2 is up, line protocol is up
Hardware is Virtual Access interface
MTU 1492 bytes, BW 100000 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP Closed
Base PPPoE vaccess
Vaccess status 0x44, loopback not set
DTR is pulsed for 5 seconds on reset
Last input never, output never, output hang never
Last clearing of "show interface" counters 4d03h
Input queue: 0/4096/0/0 (size/max/drops/flushes); Total output drops:
0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Loopback0 is up, line protocol is up
Hardware is Loopback
MTU 1514 bytes, BW 8000000 Kbit, DLY 5000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation LOOPBACK, loopback not set
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
________________________________________________________________________
Send your friends personalized video messages!
Sign up for a FREE Juno account and start sending Video Mail today!
http://track.juno.com/s/lc?u=http://ads.addynamix.com/click/2-2130421-17
7
Recent archives of the list can be found at
http://www.westnet.com/verizonisp/
Send 'unsubscribe' in the body to verizonisp-request@westnet.com to
leave.
Recent archives of the list can be found at
http://www.westnet.com/verizonisp/
Send 'unsubscribe' in the body to verizonisp-request@westnet.com to leave.
Received on Thu Aug 23 18:06:55 2007
This archive was generated by hypermail 2.1.8 : Thu Aug 23 2007 - 18:55:00 EDT