We have a 2507 with a DS3 ATM setup. We are stet-up to use aggregate PVC for
multiple end-users (How Verizio is setup). We are using RBE routing. All seemed to
be working fine till we hade one user get two DSL lines two blocks apart. Now the
problem that I found is that if the two are using the same PVC they can not route to
each other. Routing to other IP’s on other PVC’s on the same ATM works fine. Is
there any way around this?
Below is some of the 2507 config.
interface Loopback0
ip address 66.250.201.1 255.255.255.0
interface ATM1/1/0
description Verizon ATM Network
mac-address 0030.a333.d812
no ip address
atm scrambling cell-payload
no atm ilmi-keepalive
interface ATM1/1/0.319 point-to-point
ip unnumbered Loopback0
atm route-bridged ip
pvc 1/319
ip route 66.250.201.16 255.255.255.255 ATM1/1/0.319
ip route 66.250.201.22 255.255.255.255 ATM1/1/0.319
ip route 66.250.203.16 255.255.255.248 66.250.201.22
ip route 66.250.203.24 255.255.255.248 66.250.201.16
Michael Steinhart
OpCenter.net
PMH Network Services, Inc.
______________________________________________________________
Michael Steinhart OPCenter
mike@opcenter.net PMH Network Services, Inc.
http://www.opcenter.net 284 Ackerman Ave
Emerson, NJ 07630
Recent archives of the list can be found at
http://www.westnet.com/verizonisp/
Send 'unsubscribe' in the body to verizonisp-request@westnet.com to leave.
Received on Fri Nov 29 02:45:27 2002
This archive was generated by hypermail 2.1.8 : Wed Aug 27 2003 - 13:27:16 EDT